Dynaverse.net

Taldrenites => Starfleet Command Models => Topic started by: red_green on March 23, 2004, 02:05:34 am

Title: Help with extrude problem?
Post by: red_green on March 23, 2004, 02:05:34 am

Ok I use milkshape. Whenever I use extrude I get shaded triangles. Or sometimes bright ones like on the box in the pic bottom row right.  Is there someway to clean up these shade/light areas after I extrude. If I remember its mostly when I extrude into the model not out.


 check last pic foor example of problem  

Title: Re: Help with extrude problem?
Post by: Khalee on March 23, 2004, 02:21:51 am

Well I dont know anything about milkshape, But in max its either increase the poly count, add segments or just start moveing each vertex one at a time untill you get the smothest shape you can. But with low poly ships your not going to be able to hide them compleatly. That is the trade off to low poly modeling.

Title: Re: Help with extrude problem?
Post by: red_green on March 23, 2004, 04:12:33 am

OK thanks. I'll try to texture so it blends in some.  I can't model a straight line today for some reason.