Dynaverse.net

Taldrenites => Starfleet Command Models => Topic started by: Bob Graham on January 28, 2003, 11:23:55 am

Title: How do you move and change hardpoints?
Post by: Bob Graham on January 28, 2003, 11:23:55 am

I'd like to move hard points around on a few models, and was wondering how you do it?

Title: Re: How do you move and change hardpoints?
Post by: MrCue on January 28, 2003, 12:07:53 pm

with the HP editor from SFCU

 Get it here  

Title: Re: How do you move and change hardpoints?
Post by: Kaenyne on January 28, 2003, 02:28:18 pm

This hardpoint editor works only for SFC3? Or is it compatible with SFC2 or OP?  

Title: Re: How do you move and change hardpoints?
Post by: MrCue on January 28, 2003, 04:50:25 pm

dont know

Title: Re: How do you move and change hardpoints?
Post by: 3dot14 on January 28, 2003, 08:47:18 pm

Just SFC3.

In SFC2 the harpoint UI (the schematics part) is fixed. (you cannot change the number and position of those)

Title: Re: How do you move and change hardpoints?
Post by: Kaenyne on January 28, 2003, 10:21:54 pm

Yeah, thought so...oh well, at least in SFC2 you can change the type of weapon the hardpoint uses...  

Title: Re: How do you move and change hardpoints?
Post by: 3dot14 on January 28, 2003, 10:26:58 pm

not true.

SFC2 has "primary" (it's called phaser there) and "heavy" hardpoint distinctions as well.

I don't remember the scheme off hand, but you can find them clearly labeled in EagleEye's ShipEdit.

SFC does have an "omni" type of HP (that accepts both phaser OR heavy IIRC) that SFC3 doesn't.